CSI ETABS - Structural Design - Mega course

Section 1 Introduction
Theoretical-Practical Example Standard R-027 P1
Theoretical-Practical Example Standard R-027 P2
Theoretical-Practical Example Standard R-027 P3
Introduction of Steel to ETABS Method1
Introduction of Steel to ETABS Method1
P1 Introduction of Steel to ETABS Method1
P2 Introduction of Steel to ETABS Method2
Comparision Method 1 Vs Method 2 in ETABS
Short column effect theory on walls
Short column effect theory in ETABS walls
Torsion correction on ETABS Beams

Section 2 Introduction
Presentation of Project and Units in ETABS
Material Properties and Wall Thickness in ETABS
Factor System Cd, and Minoration Factors ETABS
ETABS Housing Drawing
ETABS Stair Drawing
Drawing of Interfloor Slab, and Assignment of Loads
Roof Slab Drawing, and Load Assignment
Design Spectrum R-001 P1

Section 3 Introduction
Design Spectrum R-001 P2
Design Spectrum R-001 P3
Design Spectrum R-001 ETABS
Directional combinations Earthquake X and Y ETABS
Combination of Loads R-001 ETABS
ETABS Wall Drawing
Drawing of Wall and Rigid Diaphragm
Rigidity Center Correction P1

Section 4 Introduction
P2 Stiffness Center Correction
P3 Stiffness Center Correction
P4 Stiffness Center Correction Walls capacity demand Static Vs Dynamic Cut Drift Calculation
Slab Mesh Floor
Dead Load Adjustment


Section 5 Introduction
Diaphragm and Participatory Mass Correction
Foundations Drawing
P1 Wall Mesh
P2 Wall Mesh
Foundation Meshing
Soil Allocation Foundations
Ceiling Mesh P1
Ceiling Mesh P2

Section 6 Introduction
P3 Ceiling Mesh
P4 Ceiling Mesh
Modal Analysis and Basal Cut
Dead Load Reduction
Wall Fault Correction
Design and Detailing of P1 Wall
Design and Detailing of P2 Wall
Design and Detailing of P3 Wall

Section 7 Introduction
P4 Wall Design and Detailing
P5 Wall Design and Detailing
Design by Cut and Detailed Wall
Beam design Foundation design
Foundation design P2