Roxby Training courses

...This course is designed to enable engineers and competent technicians to confidently calibrate the controls and diagnose problems in Gas Turbine SPEEDTRONIC...

...Exo and Exq Wiring systems and glanding Installation, maintenance, inspection and testing Training Aids - Practical training and assessment and the use of course hand...

...Area Classification Definitions of Zones 0, 1 & 2 Temperature Classification Concepts of Exd, Exe, Exn, Exi Ingress Protection (IP Code) Visual Inspection...

...OHP, Information hand-outs. Assessment - There is an optional City and Guilds examination on the third day of the course. This is a nationally recognised...

...and MICC cable Fault voltage operated circuit breakers & Fuses Correct use of an insulation and continuity tester 110v / 130v system including colour...

...be issued with a certificate from Roxby Training...

...principles of operation • Governing system requirements Introduction to SPEEDTRONIC Fundamentals • Introduction to control function • Fuel systems • Redundancy...

...This course is designed to instruct a qualified gas turbine operator to the modifications made to upgrade the unit to a SPEEDTRONIC Mark V Control System...

...Delegates do not do a direct assessment. However, all delegates are closely monitored to make sure they fully understand and are able to demonstrate correct procedures...

...equipment regulations 1992 Health & safety (display screen equipment) regulations 1998 Noise at work (ACOP) Training Aids - Use will be made of lecture notes...

...Terms ‘reasonably practicable’ • Exemptions to the Health & Safety at Work Act 1974 • General duties of employers i.e. safety policy, safety representatives and committees...