Carry out Dismantling Operations
Course
In Wigton
Description
-
Type
Course
-
Location
Wigton
-
Duration
3 Days
Facilities
Location
Start date
Start date
About this course
CS30, CS31, CS38 & CS39
Reviews
Course programme
Learning Outcomes:
Start Date: On demand
The candidate will be the climber and will be referred to as either the candidate or the climber in the following guidance.
Candidates must successfully achieve all Assessment Activities unless otherwise specified.
Assessment and site requirements:
• The Assessor must be able and equipped to carry out an aerial tree rescue.
• An experienced ground person must work under the direction of the candidate (the Assessor may act as the ground person).
• The assessment should be undertaken on a medium to large sized open grown tree(s), with sufficient side branches at a reasonably low level.
• The candidate should be equipped with a top or rear handled chainsaw in good condition with a maximum recommended guide bar length of 380mm (15”).
• The candidate should be equipped with a rear handled chainsaw in good condition with a maximum recommended guide bar length of 635mm (25”).
• The candidate should be equipped with sufficient fuel and oil, appropriate to the make and model of the chainsaws, for the assessment.
• The candidate should ensure that the worksite is signed as appropriate.
• The candidate should be equipped with sufficient rigging equipment to undertake the range of operations described in Unit 2.
• A spare working saw must be available.
• In addition to the relevant requirements of the Provision and Use of Work Equipment Regulations (PUWER) 1998, any ancillary equipment used for this assessment must also comply with relevant requirements of the Lifting Operations and Lifting Equipment Regulations (LOLER) 1998 where applicable.
Carry out Dismantling Operations