SolidWorks 2020 Learning by Doing 1. Car Canopy Design

"Concept Design
Introduction and Defining Variables
Creating the Main Sketch
Placing The Frames
Patterning The Side
Defining The Purlins Profile
Placing The Purlins
Verifying the Design By FEA
Defining A Material And Accessing The Analysis
Preparing The Model For The Analysis
Defining Fixtures and loads Then Running the Analysis
Model Enhancing
Modifying The Model For Enhanced Analysis Results
Rerun The Analysis With Some Enhancements
Reaction Forces
Creating The Real Model
Exporting The Variables And Defining The Main Sketch Again
The Main Frames and The Main Connection
Patterning The Other Joint
Creating Supports Plates
Placing Supports
End Caps and Column Base Plate
Purlins Plates
Purlins Placing
Rod Placing
Detailing
General Info About the Detailing
Plates Naming Part 1
Plates Naming Part 2
Naming the Remaining Elements
Creating The General Drawing
Column Detailing
Pipes 1A & 2A Detailing
Supports Detailing
30 Pipe Cutting Pattern
Purlin Detailing
Column Assembly Part 1
Column Assembly Part 2
Column Assembly Part 3
Pipe Assembly Part 1
Pipe Assembly Part 2
Exporting DWG Cutting Files 1
Exporting DWG Cutting Files 2
Exporting DWG Cutting Files 3"