Vehicle Checks & Basic Load Security - DCPC
Training
In Stonehouse
Description
-
Type
Training
-
Level
Beginner
-
Location
Stonehouse
-
Duration
1 Day
Suitable for: LGV/HGV, 7.5 tons, van drivers
Facilities
Location
Start date
Start date
Reviews
Course programme
COURSE CONTENTS
• Introduction to Driver CPC Periodic training scheme
• Duties and responsibilities of drivers
• Recording daily vehicle checks and defect reporting procedures
• Hazards associated to vehicle oils, fuels and coolants
• Personal protective equipment requirements and personal hygiene
• Checking vehicle lubrication and fluid levels in line with manufactures recommendations
• Procedures for fluid replenishment in line with manufactures recommendations
• Walk round inspection and component part identification and legal requirements
• Common fault identification and remedial action
• Regulations and accepted codes of practice concerning the safety of loads on vehicles.
• Principals of load safety
• General requirements for securing loads
• Suitability and selection of anchorage points
• Securing straps and ropes - Inspection and use
• Packing and protection of securing equipment
• Storage of load securing equipment
AIMS:
To ensure drivers maintain the safety and effective operation of their vehicle during the working day.
OBJECTIVES:
On completion of this training course Drivers will have a greater understanding of their responsibilities under the road traffic act and the provision and use of work equipment.
COURSE DESIGN:
Course designed in accordance to BS EN ISO9001 : 2000 National and International Standards, and in compliance with the Health and Safety Executive Approved Codes of Practice, Manufacturers Guidelines, achieving best practice.
Training Methods - Theoretical &
Practical exercises
REFERENCES:
Working at heights regulations
Provision and use of work equipment regulations
HSG136 Workplace transport safety
European Best Practice Guidelines on Cargo Securing for Road Transport
DFT: Safety of Loads on Vehicles (CoP)
MEASURE OF ACHIEVEMENT & CERTIFICATION:
Theoretical & Practical Exercises
C & G Services (Europe) Ltd (BS EN ISO
9001: 2000)
Vehicle Checks & Basic Load Security - DCPC
Equipment Specification
1. Suitable classroom for theory session
2. Suitable flatbed vehicle for loading
3. Selection of typical loads to secure
4. Selection of securing equipment i.e. straps/chains etc
5. Suitable practical training area
6. Means of placing loads on vehicle to secure
7. PPE
Vehicle Checks & Basic Load Security - DCPC