Engineering and Manufacturing courses Leatherhead

...All those involved or responsible for integrity of pressure equipment and control of hazardous substances. The aim of this introductory course is to provide... Learn about: Plant Engineering, Fitness for service...

...are also provided to ensure delegates receive a thorough basic understanding of EMC using a risk based approach. The complexity and diversity of modern... Learn about: Electronics Engineering...

...which might affect conformity or heighten the risk of obsolescence... Learn about: Equipment Design...

...the fundamentals of Engineering Safety Management, and advice on the practical application of the new CSM regulation. The material presented aligns... Learn about: Risk Assessment, Independent review and assessment, Hazard identification...

...on usage or where compliance with the Physical Agents Directive becomes part of the design brief. Provisions are also introduced on risk assessment... Learn about: EMF Directive...

...the application of various protection systems for a variety of buildings and systems. The course is suitable for designers of structural and electrical... Learn about: Lightning protection...

...looking at possible causes for each part. Since failures are generally expensive and cause significant disruption to power generation, the need... Learn about: Gas turbines, Failure Analysis...

...safety and systems engineering. Electrical, electronic or programmable electronic systems (E/E/PESs) increasingly carry out safety functions in all application sectors... Learn about: Software and IT, IEC 61508...

...quality management; reliability or trading... Learn about: Failure Analysis Investigation...

...A must for anyone required to accept, or who is involved in the development and management of a safety case report, this course explains the reasons... Learn about: Software and IT, Software Safety...

...life looking mostly at the hot section blading, which has the shortest life and is expensive to replace. Disc lifting is also reviewed as the design approach... Learn about: Life Management, Gas turbines...

...the course will explain the safety lifecycle, teach the techniques of Preliminary Hazard and Accident analysis (PHA) and Hazard and Operability Study (HAZOPS)... Learn about: Safety planning, Safety cases, Safety requirements...