-
All
-
Online
-
Filters
-
Location
-
Type of studies
-
+ Filters (1)
NETA Training courses
- Training
- Blended in Stockton-on-tees
- 5 Days
...basic items of rigging equipment Being aware of the statutory requirements, regulations and approved codes of practices regarding rigging equipment together...
- Training
- Blended in Stockton-on-tees
- 2 Days
...This course is intended for personnel who will be required to act on the instructions of an Appointed Person in order to supervise lifting operations...
- Training
- Blended in Stockton-on-tees
- 1 Day
...Selecting and using chains and chain slings Selecting and using wire rope slings Using 'Safe Working Load' Charts Slinging and moving loads Working...
- Training
- Stockton-on-tees
- 1 Day
...including the correct use of angles#. Pre operational checks The aim of the course is to give occasional users an awareness of the correct and safe method...
- Training
- Stockton-on-tees
- 1 Day
...Rigging Regulations and Practices of the Construction Industry...
- Training
- Blended in Stockton-on-tees
- 2 Days
...At the conclusion of this course the delegate will be capable of correctly and safely: Selecting and using chains and chain slings. Selecting and using fibre strops...
- Training
- Blended in Stockton-on-tees
- 3 Days
...They will be familiar with lifting tackle inspection procedures...
- Training
- Billingham
- 3 Days
...On completion of this training course each delegate should be capable of: Understanding the requirements of the Regulations. Checking requirements for a Standard Installation...
- Training
- Billingham
- 1 Day
...from 16th Edition IEE Wiring Regulations to the 17th Edition IEE Wiring Regulations...
- Training
- Billingham
- 2 Days
...Follow suitable inspection and testing techniques for the requirements of the AM2 test. Apply a Logical Approach to Fault Finding. Have the theoretically...
- Training
- Billingham
- 10 Days
...starting and sequential motor control. Carry out a safe isolation of electrical machinery. Suitable for: Delegates will ideally be from a Craft engineering discipline...
- Training
- Billingham
- Beginner
- 5 Days
...& identify three-phase & single phase machines... continued in objectives...
- Training
- Billingham
- 4 Days
...Delegates should have completed 17th Edition IEE Wiring Regulations Course / update course. This course is designed to give experienced electricians / supervisors...
- Training
- Billingham
...use in potentially explosive gas atmospheres...
- Training
- Billingham
- 2 Days
...scheme for electrical and instrumentation crafts persons who work in potentially explosive atmospheres in offshore and onshore industrial situations...
- Training
- Billingham
- 2 Days
...typical flammable atmospheres situations & types of release. various ignition sources & potential associated hazards. the characteristics of gases...
- Training
- Billingham
- 3 Days
...On successful completion of the course the delegate will have an understanding of: EX05 Preparation and Installation of Electrical Apparatus Protected...
- Training
- Billingham
- 5 Days
...of instrument process measurement Delegates should have an understanding of instrument process measurement The aim of this course is to enhance the skills...
- Training
- Billingham
- 1 Day
...the engineering/ construction industries. Good health and safety standards rely on employees working together to reduce risks and prevent accidents...
- Training
- Billingham
- 2 Days
...The learning outcomes of the CCNSG Nationally Accredited Safety Passport course are to increase awareness of health, safety and welfare and environmental issues... Learn about: Some knowledge of site safety is advantageous, No previous knowledge is required...