-
All
-
Online
-
Filters
Training in Stockton-on-Tees
- Training
- Stockton-on-tees
- 1 Day
...The management of health and safety at work The provision and use of work equipment The workplace health safety and welfare The display screen equipment...
- Training
- Stockton-on-tees
- 1 Day
...techniques Be able to hold effective meetings...
- Training
- Stockton-on-tees
- 3 Days
...lifting operations to the required standard as defined in BS7121 Code of Practice Part 1(General) and Part 3...
- Training
- Blended in Stockton-on-tees
- 5 Days
...This is a basic rigging course designed to suit the requirements of learners who have limited or no knowledge of Rigging, Lifting and Slinging Techniques...
- Training
- Blended in Stockton-on-tees
- 2 Days
...Suitable for: This course is intended for personnel who will be required to act on the instructions of an Appointed Person in order to supervise lifting operations...
- Training
- Blended in Stockton-on-tees
- 1 Day
...They will be familiar with lifting tackle inspection, maintenance and storage procedures...
- Training
- Blended in Stockton-on-tees
...On completion of the course delegates will be aware of: Introduction to LOLER. What is LOLER. What is contained in LOLER. Other relevant legislation HASWA...
- Training
- Blended in Stockton-on-tees
- 1 Day
...Regulation 1998 (LOLER) COURSE OBJECTIVES AM On completion of the course delegates will be aware of: Introduction What and whom PUWER applies...
- Training
- Stockton-on-tees
- 1 Day
...including the correct use of angles#. Pre operational checks The aim of the course is to give occasional users an awareness of the correct and safe method...
- Training
- Stockton-on-tees
- 1 Day
...in the use of lifting and rigging out of balance loads. Performing simple calculations used in lifting and rigging. The document control required for lifting equipment...
- Training
- Blended in Stockton-on-tees
- 2 Days
...Using 'Safe Working Load' Charts. Slinging and moving loads. Assisting with cranes and the correct use of hand signals. Calculating the weights and centres...
- Training
- Blended in Stockton-on-tees
- 3 Days
...The aim of the course is to enhance skills, enabling tasks to be performed by lifting, slinging and rigging components and equipment in a safe and correct manner...
- Training
- Inhouse in Stockton-on-tees
- 5 Days
...Solar Photovoltaic systems, from the principles of how they work through to designing, installing and commissioning a domestic system successfully...
- Training
- Stockton-on-tees
- 2 Days
...a variety of system designs have been developed and tested to meet specific consumer needs and environmental conditions. Solar hot water systems are...